SSH Connection to Host Computer

dangerous

• This document applies only to FLY host computers.
• If you are compiling or flashing firmware, please refer to the network connection tutorial instead of the serial connection tutorial.

• You can connect to the device via serial port or Wi-Fi.
• Please prepare MobaXterm_Personal or other SSH terminal tools in advance.
• Ensure that the SD card or M2WE has the corresponding host computer system flashed.
• If the host computer fails to start normally, remove peripherals such as drivers, limit switches, fans, etc.!!!
• Finally, connect via network to SSH for convenient firmware compilation!!
• For firmware compilation, please refer to the tutorials on connecting to the host computer via Wi-Fi or Ethernet cable.

Installing the System Storage Card

• Ensure that the system card has the corresponding system flashed; otherwise, it will not boot.

  

Power Supply

• Use a USB Type-C cable to connect the FLY host computer to your computer.

• Ensure that the USB Type-C cable supports data transfer!

• After the system boots, the indicator light will blink rapidly!!

• Blinking indicates that the system has started.

  
  Fly-FAST SSH Connection Tutorial

  Serial Connection

  Connecting to Host Computer SSH via Serial Port

  • If the motherboard is properly connected to the computer, you can see the CH340 port by opening the Device Manager

  

  • Open MobaXterm and set it up as shown below. Select the port previously seen in the Device Manager

  

  • Please note that Speed(bps)* should be set to 115200

  

  • If everything is working properly, you will see the boot screen
  • After a short wait, the screen shown below means the system has started

  

  If after waiting a few minutes, the screen appears as shown below without any display, simply press the Enter key several times

  

  • Please note that if it is the FAST system, you need to enter a username and password, and the password will not be visible as you type

  • FlyOS-FAST default username is root, and the default password is mellow

  • After pressing Enter, the following content will be displayed

    

  tip

  • The appearance of the screen below indicates successful login
  • The FAST system updated the appearance below in version V1.3.0

  

  • If you need to check the device IP, ensure that the Ethernet cable is connected or the WIFI is properly connected Connect to WIFI

  Network Connection

  Connecting to Host Computer SSH via Network IP

  • Please log in to the router admin panel to which the host computer is connected, unless you already know the host computer's IP address
  • Please ensure that you are aware of the host computer's username and password
  • FlyOS-FAST default username is root, and the default password is mellow
  • If the motherboard has already booted and is connected to the network, you can use the following method to connect to SSH
  • Open MobaXterm and set it up as shown below. Enter the IP address previously checked, which can also be found in the router admin panel

  

  Note: In step 4 here, enter the username of the host computer

  

  • When connecting for the first time, this window will pop up. Click Accept to proceed

  

  • When prompted for a password, press Enter after entering the host computer's password

  Note: The password entered here will not be visible. Simply press Enter after typing it in

  • For the FLY-FAST system, the username is: root, and the password is: mellow

  

  tip

  • The appearance of the screen below indicates successful login
  • The FAST system updated the appearance below in version V1.3.0

  

  • Successfully logged in