📄️ Introduction
Product Features
📄️ Firmware Update
* The device comes pre-flashed with firmware from the factory.
📄️ Connect WiFi
* The built-in antenna of this product can only be used for receiving. The sending antenna needs to be installed by yourself, and the antenna terminal is ipex3.
📄️ Connect to Klipper
* AirClick must be connected to the same network as the target printer
📄️ Connect to RRF
* AirClick must be connected to the same network as the target printer
📄️ Connect to BambuLab
* AirClick must be connected to the same network as the target printer
📄️ Add Button
* The wireless button requires a battery to be installed, the battery model is CR927
📄️ Wired Connection Klipper Configuration
* The STM32F072 must be flashed with firmware and connected to Klipper; otherwise, wired connection operations are not supported.
📄️ 3D Models
AirClick 3D Models